Home > Shop by Category > Garage Doors & Openers > Replacement Parts
Sort By:
Page of 1
Limit Switch 10A 125/250VAC Limit Nut 10k ohm End of Line Resistor
Limit Nut
Our Price: $5.00
Limit Switch 10A 125/250VAC
Nylon Limit Nut for Limit Shaft

  • Limit Nut 1/2-20, 1B,
  • Used to Set Limits on a limit shaft
  • Used with limit switches
For Fire Fly- 10k ohm End of Line Resistor
DPDT 24v 10A AC Relay DPDT 230v 10A 120-240v 24VAC Transformer, 21-14182,
DPDT 24v 10A AC Relay
Our Price: $18.00
DPDT 230v 10A
Our Price: $18.00
120-240v 24VAC Transformer
Our Price: $25.00

(1)
DPDT 24v 10A AC Relay
DPDT 230v 10A
LiftMaster 120-240 Volt to 24 Volt AC Power Transformer

-Used for Commercial Operators.
-Works with Micanan and LiftMaster Motors

460V 24VAC Transformer, 21-35057 20' Coil Cord 240v 60hz Brake Solenoid, 22-240
460V 24VAC Transformer
Our Price: $25.00
240v 60hz Brake Solenoid
Our Price: $44.00
460 Volt to 24 Volt AC Power Transformer

-Used for Commercial Operators.
-Works with Micanan and LiftMaster Motors

Coil Cord
-20' Length
-18 Gauge Wire
-2 Wire Conducting System
-Primarily used to be connected between a motor operator and a bottom sensing edge



240v 60hz Brake Solenoid
Made for commercial motor operators to engage the brake
22-120, 120v brake solenoid 20' Cord Reel, Take up Reel Cast Motor Vertical Mounting Bracket
120V 60hz Brake Solenoid
Our Price: $45.00
20' Cord Reel, Take up Reel
Our Price: $45.00

(1)
Brake Solenoid for Commercial Operators

120V 60hz Brake Solenoid to engaged brake
Cord Reel
-20' Cord Reel
-Also known as a take up reel
-Primarily used to conduct a presence on a safety edge on a door or gate
-Used between the motor operator and the sensing edge
-2 Wire System

LiftMaster MODEL 089098-Cast Angle Mounting Bracket

  • Heavy 1/2 inch thick cast iron angle bracket used four mounting side-mount operators on the end bracket of a rolling door or grille.
  • May be used for vertical or horizontal mount and either front of coil or top of coil mount.
  • Curved slots in bracket allow for tensioning of chain drive. Right/left interchangeable. Operator mounting holes match up with mounting dimensions of LiftMaster Model J, MGJ, H and GH operators (also see EZ Mount description)

NOTE: Cannot be used with model GH 300.

Used with LiftMaster Gear Head Operators
Timer to Close
Timer to Close
Our Price: $120.00
Artisan Timer to Close for a Commeercial Operator
Timer 19-288v 50/60hz 10%